Technical Manual Presence Detector SCN-P/G360XX.02
MDT technologies GmbH •
51766 Engelskirchen • Papiermühle 1
Tel.: +49-2263-
880 •
Fax: +49-2263-4588
• [email protected] • www.mdt.de
31
31
Follow-up time
The follow-up time describes the time that expires after the last detection of a motion until the
output is switched off. For example, with a follow-up time of 3 minutes, the light would be switched
on for at least 3 minutes with motion detection. Each new detection leads to a retriggering and thus
to a restart of the follow-up time..
Locking or enabling object
To lock or enable the alarm channel, you can activate a lock or enabling object. The lock object
switches off the channel with a 1, the enable object activates the alarm channel with a 1..
Separate switch object at night
This parameter displays a separate switch object for night mode..
Output object sends at
This parameter can be used to activate a sending filter for the output. If you want the output to send
only ON commands, you have to use the setting "only ON".
Output object sends cyclic
Activation of cyclic sending for object 50 "Alarm - output 1".
The following table shows the corresponding communication objects:
Number
Name
Length
Usage
50
Alarm
–
Output 1
1 Bit
Output of the Alarm function
51
Alarm
–
Night mode
1 Bit
Output of the Alarm function at night mode
56
Alarm Input
–
Lock
1 Bit
Locking the alarm function
56
Alarm Input
–
Enable
1 Bit
Enabling the alarm function
Table 14: Communication objects - Alarm function
