PELLET STOVES
Chapter 4
USE AND MAINTENANCE MANUAL
page
34
Operation
Technical dept. - All rights reserved by MCZ Group S.p.A. - Reproduction prohibited
D
E
ON
OFF
and continuation of ventilation until the stove has cooled down
sufficiently. This phase can last from 20 to 40 minutes depending on
how long the stove was on for and its position.
4.7.2.
Note regarding first start-up
The first start-up may actually fail, since the auger is
empty and does not always manage to fill the brazier
up quickly enough with enough pellets for the flame
to ignite normally
CANCEL THE ALARM STATUS (A02) VIA THE
EMERGENCY PANEL (see paragraph 4.17), REMOVE
THE PELLET REMAINING IN THE BRAZIER AND
REPEAT START-UP
If, after a repeated number of start-up attempts, there is still no flame
despite a regular supply of pellets, check the brazier is correctly seated.
The brazier must be seated
perfectly inside its slot and free of any
ash deposits
. If no abnormalities are detected there may be a
problem with the stove components or installation may have been
carried out incorrectly.
REMOVE THE PELLET FROM THE BRAZIER AND CALL
FOR AN AUTHORISED MCZ TECHNICIAN.
4.7.3.
Start-up/ shutdown via the emergency panel
If the remote control is faulty or the batteries are flat you can operate
the stove temporarily using the emergency panel on the rear of the
stove.
In this configuration, the stove can be operated manually and you can
choose between
3
power levels.
STARTING UP THE STOVE WITHOUT THE REMOTE
CONTROL
To start up the stove move selector
“D”
to the
ON.
When the
stove starts up the RED LED will switch off and the GREEN LED
will begin to flash until the start-up process is complete. The
GREEN LED stays on permanently while the stove is running.
SELECTING THE POWER LEVEL WITHOUT THE REMOTE
CONTROL
You can choose between three heating power levels:
MIN-MED-MAX
(selector
“E”
)
MINIMUM
power is the 1
st
power level;
MEDIUM
power is the 3
rd
power level;
MAXIMUM
power is the 5
th
power level;
SHUTTING DOWN THE STOVE WITHOUT THE REMOTE
CONTROL
To shut down the stove move selector
“D”
to the
OFF
