PELLET STOVES
Chapter 4
USE AND MAINTENANCE MANUAL
page
32
Operation
Technical dept. - All rights reserved by MCZ Group S.p.A. - Reproduction prohibited
4.5.
EMERGENCY PANEL
The emergency panel is located on the side of the stove, at the bottom.
This panel is designed to diagnose any operating faults and is needed
to control the stove if the remote control is not working.
KEY
A.
Three-figure display showing a series of information about the
stove as well as the ID code for possible operating faults.
B.
GREEN
LED that gives the following indications:
OFF = Stove off
FLASHING = Stove starting up
ON = Stove on
C.
RED
LED that gives the following indications:
OFF = Stove on
FLASHING SLOWLY = Stove switching off
FLASHING RAPIDLY = Stove in alarm status
(accompanied by an acoustic beep for the first 10
minutes)
ON = Stove off
D.
Three-position selector for the function
OFF = Stove manually switched off with remote control
absent
REMOTE = Stove can
only
be controlled by the remote
control
ON = Stove manually switched on with remote control
absent
E.
Three-position selector for power selection
MIN = Selector to operate the stove at MINIMUM power
with remote control absent and selector
4
set to ON
MED = Selector to operate the stove at MEDIUM power
with remote control absent and selector
4
set to ON
MAX = Selector to operate the stove at MAXIMUM power
with remote control absent and selector
4
set to ON
F.
Button for diagnostic functions relating to the operation of the
stove
G.
Button to enable communication between the stove and a new
remote control (via the process explained below)
TO ALLOW THE STOVE TO OPERATE WITH
THE REMOTE CONTROL, SELECTOR "D" MUST
BE SET TO "REMOTE"
