PELLET STOVES
Chapter 4
USE AND MAINTENANCE MANUAL
page
28
Operation
Technical dept. - All rights reserved by MCZ Group S.p.A. - Reproduction prohibited
4.2.
CHECK PRIOR TO START-UP
Check all the safety conditions covered previously.
Make sure you have read and fully understood the contents of this
instruction manual.
Remove all components which could burn from the combustion
chamber and glass (polystyrene, adhesive labels and instructions).
Check that the brazier is positioned correctly and rest it well on the
base.
If the front cladding of the stove is made from white
painted metal it must be removed when the stove is
started up for the first time.
This prevents smoke, produced by the drying paint,
from damaging the colour.
Following long periods in which the stove is not used,
remove any remains of pellets from the tank (
using a
vacuum cleaner with a long pipe).
Pellet remains that
have been lying in the stove for some time may have
absorbed moisture, changing their original characteristics and
making them no longer suitable for combustion.
4.3.
LOADING PELLETS
The fuel is loaded via a flap on the side of the stove. Pour the pellets
into the tank. The empty tank holds approximately 18 Kg.
Do not put any type of fuel into the tank other than
pellets that comply with the specifications indicated
above.
4.4.
LCD REMOTE CONTROL
4.4.1.
General characteristics of the LCD remote control
The stoves are mainly controlled via the remote control. They can also
be operated via the small panel on the rear of the stove in the event of
an emergency.
The LCD radio frequency remote control allows you to make full use of
the stove's functions, adjust all of the operating parameters, set the
timer and, above all, constantly monitor the temperature of the room in
relation to the operating output of the stove.
In fact, the room sensor is directly included in the remote control to
allow you to measure the temperature in the room to be heated more
accurately, no matter where the user desires, without the restraint of
inconvenient, restrictive cables fixed to thermostats.
The remote control is fitted with a bright blue backlight that is activated
at the press of a button.
Position of the room temperature sensor
