McQuay AGZ 035A, Инструкция по установке, эксплуатации и обслуживанию

Страница: 92 / 96

92 AGZ 035A through 065A IOMM AGZ-3
3. The charge can be added at any load condition between 25-100% load per circuit but at least two F
fans should be operating per refrigerant circuit if possible. The suction superheat should be in the
6
°
F-12
°
F (3.3
°
C-6.6
°
C) range.
4. Add sufficient charge to clear the liquid line sightglass and until all flashing stops in the sightglass.
Add an extra 15-20 lbs. of reserve to fill the subcooler if the compressor is operating at 50-100%
load.
5. Check the unit subcooling value by reading the liquid line pressure and temperature at the liquid
line near the filter-drier. The subcooling values should be between 6
°
F-20
°
F (6.6
°
C-11.1
°
C). The
subcooling values will be highest at 75-100% load, approximately 12
°
F-20
°
F (6.6
°
C-11.1
°
C) and
lowest at 50% load, approximately 6
°
F-12
°
F (3.3
°
C-6.6
°
C).
6. With outdoor temperatures above 60
°
F (15.6
°
C) all condenser fans should be operating and the
liquid line temperature should be within 5
°
F-10
°
F (2.8
°
C-5.6
°
C) of the outdoor air temperature. At
25-50% load the liquid line temperature should be within 5
°
F (2.8
°
C) of outdoor air temperature
with all fans on. At 75-100% load the liquid line temperature should be within 10
°
F (5.6
°
C) of
outdoor air temperature with all fans on.
7. Overcharging of refrigerant will raise the compressor discharge pressure due to filling of the
condenser tubes with excess refrigerant.