McNeilus 1487747, Операция, обслуживание и запчасти, Страница: 25 / 75

Extreme 9" Monitor/DVR System © 2014 McNeilus Truck and Manufacturing, Inc.
21
Main Menu Functions
Distance Grid on Monitor for Alley Camera
Distance grid function is only available if selecting the single camera configuration.
To access the Grid function, enter the OSD Main Menu, select Camera Setting , select Rear Grid Setting, select
the camera to adjust.
•
Change the grid’s unit of measurement
Select Unit to format the grid’s unit of measurement in either feet or meters.
•
Set grid line measurements on the screen
Before setting grid lines, make sure the camera has a clear field of view, especially if grid line set up must be
completed indoors as walls, posts, etc., may interrupt the field of view.
With the parking brake applied, power up the monitor system by turning the vehicle’s ignition to “on” and placing
the transmission in reverse gear. DO NOT START THE ENGINE UNLESS IT IS NECESSARY TO ENGAGE
REVERSE GEAR.
The following measurements are recommended by McNeilus.
1. Select Grid .
2. Select the camera that you want to set up with a distance grid.
3. Turn the display of the grid on/off on the monitor.
4. Make sure the camera is pointing downward so that you can see the desired image from the vehicle.
5. Use a measuring tool (such as a tape measure) to mark out the distance behind the vehicle. Use objects
such as safety cones to identify the lines during measuring.
Line 4: The distance directly next to the vehicle, which is the bumper of the vehicle (0 feet from vehicle), is
the Red Line on the monitor screen.
Line 3: Measure 3.7 feet from the edge of the bumper out from the vehicle. This distance is the Blue Line
on the monitor screen.
Line 2: Measure 7 feet from the edge of the bumper out from the vehicle. This distance is the Yellow Line
on the monitor screen.
Line 1: Measure 9 feet from the edge of the bumper out from the vehicle. This distance is the Green Line
on the monitor screen.
6. Adjust the Line dimensions (Line 1, Line 2, etc.) to match the dimensions given above (these are the
lines that will display on the monitor). For each line dimension, press the right arrow to increase or the left
arrow to decrease the achieve the desired measurement. Press OK to save. Dimensions move in 1/2 foot
increments.
See the illustrations for the Left Alley Camera and the Right Alley Camera grids on Page 22.
Horizontal Line Set Up for Alley Camera
1. Set the Horizontal Lines (Line H1 and Line H2) for a particular camera
• The Horizontal Lines are measured from the center of the camera view to each side of the vehicle.
You should always confirm the view is sufficient for your needs prior to each vehicle use.
See the illustrations for the Left Alley Camera and the Right Alley Camera grids on Page 22.