McIntosh MX134, Руководство пользователя

Страница: 9 / 60

9
Installation
The MX134 can be placed upright on a table or shelf,
standing on its four feet. It also can be custom installed in a
piece of furniture or cabinet of your choice. The four feet
may be removed from the bottom of the MX134 when it is
custom installed as outlined below. The four feet together
with the mounting screws should be retained for possible
future use if the MX134 is removed from the custom instal-
lation and used free standing. The required panel cutout,
ventilation cutout and unit dimensions are shown.
Always provide
adequate ventilation
for your MX134. Cool
operation ensures the
longest possible oper-
ating life for any elec-
tronic instrument. Do
not install the MX134
directly above a heat
generating component
such as a high pow-
ered amplifier. If all
the components are
installed in a single
cabinet, a quiet run-
ning ventilation fan
can be a definite asset
in maintaining all the
system components at
the coolest possible
operating temperature.
A custom cabinet
installation should
provide the following
minimum spacing di-
mensions for cool op-
eration. Allow at least
2 inches (5.08cm)
above the top, 2
inches (5.08cm) be-
low the bottom and 1
inch (2.54cm) on each
Installation
6 -
5/8
"
16.83cm
17-
1/16
"
43.34cm
Cutout Opening for Custom Mounting
MX134 Front Panel
Custom Cabinet Cutout
Cutout
Opening
for
Ventilation
Cutout Opening for Ventilation
Support
Shelf
Cabinet
Front
Panel
Chassis
Spacers
MX134 Side View
in Custom Cabinet
MX134 Bottom View
in Custom Cabinet
13"
33.02cm
13"
33.02cm
15"
38.10cm
1"
2.54cm
14-
1/4
"
36.20cm
10-
7/8
"
27.64cm
Notes: Center the Cutout Horitzonally on unit.
For purposes of clarity, the above
illustration is not drawn to scale.
side of the A/V Control Center, so that airflow is not ob-
structed. Allow 21 inches (53.34cm) depth behind the front
panel. Allow 1-1/8 inch (2.9cm) in front of the mounting
panel for knob clearance. Be sure to cut out a ventilation
hole in the mounting shelf according to the dimensions in
the drawing.