46
How to Operate the Surround Mode
The MX134 provides eight different Surround Modes. The
Front Panel Alphanumeric Display and the Output Format
LEDs will indicate the Surround Mode selected. The Sur-
round Mode Selected is stored into permanent memory and
automatically recalled any time that particular input is se-
lected again. If the Surround Mode is changed when the
input is again selected, the new mode will be active and
stored. Refer to figure 52.
Note: The Remote Control may also be used to make changes
to the
Surround
Modes.
Refer to
figure
53.
Stereo Mode
A Stereo signal source con-
nected to an Analog Audio In-
put is reproduced without any
processing. The Front Panel
Alphanumeric Display will in-
dicate PURE STEREO. When
a Digital Audio Input is se-
lected in stereo mode, the Front
Panel Alphanumeric Display
will indicate DSP STEREO.
All multi-channel signal
sources are combined and re-
duced to 2 channels in the ste-
reo mode. The Output Format
LEDs L, R and SUB will illu-
minate. Refer to figures 54, 55
and 56.
Note: If the Subwoofer was
turned OFF in the
SPEAKER SIZE setup,
the OUTPUT FORMAT
SUB LED will not
illuminate.
Music 3
The ambience present in Stereo Recorded Music is rein-
forced by Digital Signal Processing using Dolby Pro Logic
II Circuitry. The Left and Right Dif-
ference Signal is sent to the Left
and Right Surround Loudspeakers.
The Left and Right Stereo signals
are combined and sent to the Center
Loudspeaker. The Front Panel Al-
phanumeric Display will indicate
MUSIC 3. The Output Format
LEDs L, C, R, LS, RS and SUB will illuminate. The PRO
LOGIC II Display will also illuminate. Refer to figures 57
and 58.
Music 2
This processing mode creates an effect similar to listening
in a smaller room and will enhance pop and rock music.
Left and Right Stereo signals are
combined and sent to the Left and
Right Surround Loudspeakers with
a fast decay time. The combined
Left and Right signals are also sent
to the Center Loudspeaker. The
Front Panel Alphanumeric Display
will indicate MUSIC 2. The Output
Format LEDs L, C, R, LS, RS and SUB will illuminate.
Refer to figures 59 and 60.
Figure 53
Figure 52
Figure 55
Figure 56
Figure 60
Figure 58
Figure 54
Figure 57
Figure 59
Содержание MX134
Страница 35: ...35 Notes...
Страница 51: ...51 Notes...
Страница 60: ...McIntosh Part No 040754 McIntosh Laboratory Inc 2 Chambers Street Binghamton NY 13903...