McIntosh MX134, Руководство пользователя

Страница: 42 / 60

42
center of the front panel display. Zone B is not affected by
the front panel VOLUME Control. Zone B (Record) vol-
ume level is adjusted only in Zone B with a Remote Con-
trol or Keypad. Refer to figure 36.
System Off
Normally, Remote Zones are turned On and Off individu-
ally in each respective zone by pressing the Power Push-
button on a Keypad or Remote Control. If you desire to
switch Off all zones of an entire McIntosh System simulta-
neously, including a control center and accessory source
components, you can press the SYS OFF Push-button on
the MX134 Front Panel. Refer to figure 36.
Note: The Sys Off Push button on a Keypad or Remote
Control may also be used to switch Off the entire
system.
Record Lock
The RECord LOCK Push-button allows for disabling of the
INPUT B (record, Zone B) Selector Switch while a record-
ing is in process.
Setup
Pressing the SETUP Push-button activates the MX134
SETUP Mode for making changes to the Home Theater
System.
Tuning
The TUNING Up and Down Push-buttons allow for
tuning to the next FM or AM Radio Station when the op-
tional TM1 Tuner Module is installed.
Select
When the MX134 has the optional TM1 Tuner Module in-
stalled, the SELECT Push-button allows for selecting ei-
ther the FM or AM Broadcast Bands.
Enter
When the MX134 has the optional TM1 Tuner Module in-
stalled, the ENTER Push-button is used for entering an AM
or FM Broadcast into memory.
Preset
The PRESET Left and Right Push-buttons allow for
selecting the next FM or AM Radio Station that has been
stored into memory, when the optional TM1 Tuner Module
is installed.
Back Channel Mode
The BACK CHANNEL MODE Push-button on the Front
Panel of the MX134 permits the temporary
override of the MX134 Setup Menu Surround
Mode Setting. The Back Channel Surround Pro-
cessing may be switched On or Off, when the
SURROUND MODE Selector is set to the THX
CINEMA position. After the MX134 is placed
into standby and switched back On, the status
of the Back Surround Loudspeakers will revert to the Setup
Menu Surround Mode Setting. Refer to figures 37, 38 and
39.
Note: The Surround Mode THX and/or DTS Menu Settings in
the MX134 SETUP need to be set to either On or Auto
in order to reproduce the Back Channel Surround
Information. If the incoming Digital Signal contains a
DTS Discrete ES Sound Track, the MX134 will
automatically switch On the Back Surround Channels
regardless of the BACK CHANNEL MODE Selection of
On or Off.
Figure 37
Figure 36