MaxPro PROFESSIONAL 111-1402, Руководство пользователя

Страница: 6 / 18

6 GB
７
GB
ENVIRONMENT
Do not dispose of electric tools, accessories and packaging together with household waste material -
in observance of European Dir ecti ve 2002/96/EC on waste of electric and electronic equipment and its
implementa tion in ac cordance with na tional l aw, electric tools that have reached the end of their life must
be collected separately and returned to an environmentally compa tible recycling facility.
TROUBLE SHOOTING
Fault Symptom Possible Cause Tr oubleshooting
Motor noise not normal Spray gun not clean, or not
lubricated, resul
tin g in piston being
stuck in cylinder
Disassemble spray gun and clean
with thinner
Motor hums but does not spray
or irregular spraying
Worn swirl head Replace swirl head
Pick up pipe not in the right
position
Re-adjust pick up pipe
Blocked pick up pipe Clean with thinner
Blocked nozzle Clean nozzle
Block ed fil ter Clean with thinner
Control knob needs adjustment Adjust
Atomization is not good
Over painting Spray gun not clean, or not
lubricated r
esulting in piston being
stuck in cylinder
Disassemble spray gun and clean
with thinner.
Too much paint Adjust the volume clockwise to
reduce spraying. Two thin
coats are be
tt er then one
Viscosity too low Check viscosity
Operating sound not right Poor output adjustment Re-adjust
Not enough paint in the container
r
esulting in air being suc ked in
Re fill with pai nt
Not diluting properly or not
passing pick up pipe completely
Check pick up pipe and viscosity
level
“Orange Skin” excessive fogging Incorrect solvent is used Use correct solvent
Spray gun too far from the surface Hold spray gun closer to the object
Paint too thick
Thin the paint
Little or no material flow Nozzle clogged.
Suction tube clogged.
Material volume setting
turned too low(-).
Suction tube loose.
No pressure build up in container.
Air filter clogged.
Clean.
Clean.
Increase volume setting (+).
Insert.
Tighten container.
Change.
Material leaking Nozzle loose.
Nozzle worn.
Nozzle seal worn.
Material build-up on air
cap and nozzle. Tighten.
Replace.
Replace.
Clean.
Viscosity of material too high.
Material volume too large.
Material volume setting too
high (+).
Nozzle clogged.
Air filter clogged.
Too little pressure build-up in
container.
Thin.
Decrease volume setting (-).
Decrease volume setting (-).
Clean.
Change.
Tighten container.