Maxon BMR-35, Руководство по обслуживанию

Страница: 28 / 49

11921
Slauson
A
ve.
Santa
Fe
Springs,
CA.
90670
(800)
227-41
16
FA
X
(888)
771-7713
PAGE 28
SWITCH AND HARNESS REPLACEMENT
6.
Remove the middle light from a 3 light Column, or the top light on a 2 light
Column. Inside the light mounting hole near the top, loosen but do not remove
the nut that fastens the clamp to the Column, so that the cable will slide freely
through the clamp.
7.
Remove the Cover from the
top of the Column. Pull the side
of the harness attached to the
fishing rope in an upward
direction until the splice is
exposed. Move to the ground
and continue pulling the harness
in a downward direction until the
splice is again exposed.
Remove the old cable and
attach the Column Cable
8.
Place the Flexing Cable Assembly (P/N 260533),
and the Closing Cylinder Hose through the Spring
Guard.
NOTE: Be sure the Flexing Cable is located
on the Platform side of the Spring Guard, and is
parallel, not twisted with the hydraulic hose.
Replace the Spring Guard in the Runner Channel
with the bolts, clamp and plastic tube that was
removed earlier. After attaching the Switch Cable to
the Flexing Cable, pull the Connector-Plug end of
the Flexing Cable snug through the top of the
Spring Guard. Tighten the clamp that secures the
Spring to the Runner. Replace the Closing Cylinder
hose and make the proper connections for the
Flexing Cable and the Column Cable.
Assembly (P/N 260534 less the Connector-Receptacle).
Pull the new cable through in reverse order. Replace the
Cover on the Column. Tighten the clamp in the light
mounting hole and replace the Light.
COVER PLATE
FISHING
ROPE
P/N 260534
P/N 260533
FLEXING
CABLE
SWITCH
CABLE
COLUMN
CABLE