Maxon BMR-35, Руководство по обслуживанию

Страница: 9 / 49

11921
Slauson
A
ve.
Santa
Fe
Springs,
CA.
90670
(800)
227-41
16
FA
X
(888)
771-7713
PAGE 9
VALVE
BLOCK
NUT
4.
Remove the Nut from the Elbow on the top
of the Cylinder. Loosen, but do not remove the
Nut on the Elbow of the Valve Block.
NUT
5
. Remove the Roll Pin & Pin that fastens the
Rod End of the Lift Cylinder to the Runner
Assembly. Using a device such as a Chain
Hoist, hold the Lift Cylinder while removing the
upper Roll Pin & Pin. Remove the Lift Cylinder
from the top of the Column.
CHAIN
HOIST
LIFTING
CYLINDER
COLUMN
RUNNER
ASSEMBLY
PIN
PIN
6.
Remove the Plug from the
compression fitting on the New Lift
Cylinder. Fasten a Drain Hose with a
1/4” NPT Female end to the
compression fitting. Place the other
end of the Hose in a 1 gallon
container for bleeding. Pull the Rod
End of the Cylinder until the distance
between the Pins are the same as
measured in Step 1. Re-attach the
Hyd. Lock Valve and Pressure Comp.
Valve with all their fittings.
NOTE: Be sure the arrow on the
Pressure Comp. Valve is pointing up.
LIFT
CYLINDER
DRAIN
HOSE
HYD. LOCK,
PRESS. COMP.
VALVE
LIFT CYLINDER REPLACEMENT
?