Maxon BMR-35, Руководство по обслуживанию

Страница: 12 / 49

11921
Slauson
A
ve.
Santa
Fe
Springs,
CA.
90670
(800)
227-41
16
FA
X
(888)
771-7713
PAGE 12
LIFT CYLINDER REPLACEMENT
CHAIN
HOIST
LIFTING
CYLINDER
COLUMN
RUNNER
ASSEMBLY
PIN
PIN
13.
Lower the New Lift Cylinder
through the top of the Column.
Fasten at the top with the Pin &
Roll Pin. Then fasten at the Rod
End of the Cylinder with the Pin &
Roll Pin.
VALVE
BLOCK
CYLINDER
NUT
NUT
14.
Re-connect the Nut to the Elbow on top
of the Cylinder. Re-install the Valve
Cartridge, Coil, and Coil Nut to the Hyd. Lock
Valve. Re-attach the Hyd. Lock Valve to the
Column (if needed). Re-connect the Cylinder
Nut to the Hyd. Lock Valve.
COIL
NUT
12.
Remove the Plug from the
compression fitting on the New Lift
Cylinder. Fasten a Drain Hose with a
1/4” NPT Female end to the
compression fitting. Place the other
end of the Hose in a 1 gallon
container for bleeding. Pull the Rod
End of the Cylinder until the distance
between the Pins are the same as
measured in Step 1. Re-attach the
Hyd. Lock Valve and Pressure Comp.
Valve with all their fittings.
NOTE: Be sure the arrow on the
Pressure Comp. Valve is pointing up.
LIFT
CYLINDER
DRAIN
HOSE
HYD. LOCK,
PRESS. COMP.
VALVE
?