Maxon BMR-35, Руководство по обслуживанию

Страница: 16 / 49

11921
Slauson
A
ve.
Santa
Fe
Springs,
CA.
90670
(800)
227-41
16
FA
X
(888)
771-7713
PAGE 16
RUNNER REPLACEMENT
INSTALL NEW RUNNERS
10
. Remove the remaining parts of
the two Tandem Roller Assemblies
from the Old Runners and place
them on the New Runners. The
remaining parts for each Tandem
Assembly consist of: (1) Roller
Bracket Weldment, (3) Roller Axles,
and (2) Mounting Brackets.
ROLLER BRACKET
WELDMENT
ROLLER
AXLES
MOUNTING
BRACKET
12
. Replace the Upper and Lower Pads
on the front and back of the Runner.
PADS
13
. FOR R.H. RUNNER ONLY, tie a 10 ft.
piece of wire to the electrical cable that
was removed from the Switch. Insert the
opposite end of the wire through the
bottom of the Runner and bring it out
through the Switch opening in the Runner.
11
. Position the New Runner into the Column.
Replace the Rollers on the Roller Axles and
fasten them with the Washers and Nuts. Be
certain the Roller Axels are positioned against
the Roller Bracket Weldment so they don’t rotate on the Bracket.
14
. If the Lifting Cylinders were detached from the Column, replace them and
fasten them back to the top of the Column with the Pin and Roll Pin. Tighten
or replace any hydraulic fittings you may have removed from the top of the
Cylinder. Replace the Cover on the Column.