Matrox Graphics Card – User Guide
11
Windows NT 4.0 –
1
Press [Ctrl]+[Alt]+[Del]
"
[Tab]
"
[Tab]
"
[Enter]
"
[
$
] (down arrow)
"
[Enter] to
restart your computer.
2
From the startup menu, choose Windows “VGA mode”.
Main troubleshooting
This section addresses possible problems that could prevent you from using your computer.
Problem
Computer doesn’t display information or boot after Matrox card is installed
1
Cause
Your Matrox card may not be properly installed.
1
Solution
Make sure your Matrox card is properly installed. Specifically, make sure the card is firmly
inserted in its expansion slot and that all connections to it are firmly in place. For more
information,
see “Hardware installation”, page 2
.
2
Cause
There may be an unsupported graphics adapter in your computer. (For Matrox multi-display
mode in Windows NT, all graphics cards in your computer must be Matrox cards supported
by the display driver.)
1
Solution
If an unsupported graphics card is plugged into an expansion slot, remove it.
2
Solution
If a graphics adapter is built into your computer motherboard, your system may not have
automatically disabled it when you inserted your Matrox card. Check your system manual
for instructions on how to disable your computer’s built-in graphics adapter.
3
Cause
Your computer BIOS (Basic Input/Output System) may not be up to date. For more
information on your computer BIOS, see your system manual.
1
Solution
Reinstall your previous graphics card and, if possible, update your computer BIOS. This can
usually be done with software from the manufacturer of your computer. Contact your system
vendor or manufacturer to get a BIOS update for your computer.
To get the correct BIOS update, you may need to know the serial number your computer
displays when it restarts. (This number is usually in the lower-left corner of the display.)
NT
NT
