MASCAR 5100 S, Руководство по эксплуатации и обслуживанию

Страница: 36 / 38

Wrapper 5100
SECTION 6
Spare parts
6.1 SPARE PARTS
All the wrapping machine’s components can be
requested from the Manufacturer by specifying:
- Machine model
- Machine’s serial number
-
Year of manufacture
- Serial number of the part required (to be
found in the spare parts catalogue),
descprition of the part and relevant quantity .
- Means of transport. In the event this piece of
information is not specified, the
Manufacturere, though going to great lengths
to ensure this service is satisfactory, cannot
be held responsible for dealys in shipment
owing to force majeure. The transport
expenses are always at the buyer’s expense.
The goods are transported at he csutomer’s
risk and peril,e ven when sent on a carraige
paid basis.
Lastly, remember that the Manufacturer is always
on hand to help with enquiries and/or spare parts
requests.
SECTION 7
Fittings
7.1 COMPUTER MC 300
The computer indicates to the operator the end of
wrapping phase. With the MC 300 you could set
the wrapped numbers used for a full and complete
dressing.
When there are 2 round remaining the computer
emits an acoustic and bright signal. Then at the last
round it emits the same acoustic and bright signal
but this time this unceasing, letting the operator
knows that the bale has been wrapped fully.
fig. 38 - Computer MC 300
Programming of the MC 300
Key A
– Double function: programming
confirmation, and number of programmed
dressing.
Key B – Multi-purposes: shows total
number of bales, reset the counter (has to be
pressed for longer than 3 seconds). Reduces
the number of dressing during the
programming with the A key.
Key C – Multi-purposes: shows partials
number of bales, reset the counter of partial
bales (pressed for 3 seconds) increase the
number of dressing during the programming
with A key.
Key F – Power ON/OFF with green LED.
Connector E - Feeding 12V DC.
Connector D - Connection cradle rotating
sensor.
USE & MAINTENANCE MANUAL - 36 -