MASCAR 5100 S, Руководство по эксплуатации и обслуживанию

Страница: 26 / 38

Wrapper 5100
STEP 1: Loading
To advance near the bale.
To lower loading fork (fig.9, lever A) till about 10
cm from the soil.
To check, that the cradle is aligned on working
position (as in fig.22), to reverse the rotation of
the cradle (fig.9, lever B) till the stop.
To advance with the machine till completely
housing of the bale in the fork.
To lift and load the bale (fig.23) through the fork
control lever (fig.9, lever A).
To lower the fork till the soil to prepare the
machine for the wrapping.
fig. 22 – Preparation
fig. 23 – Loading
STEP 2: Wrapping
To ensure that the fork is lowered not more than
30 cm from the soil and that the rear platform is in
horizontal position.
WARNING
Don’t set in action the cradle rotation when the
fork and the platform are lifted.
Set in action cradle control towards down if
the platform is lifted (fig. 9, lever C).
To start slowly the wrapping choking the cradle
rotation control (fig.9, lever B) for the first two
tours (fig. 24).
During that step the bale, even if it has been
loaded light crooked, must to stabilize and to
centre itself in the cradle. In the same time the
clamp automatic unblock device, open the clamp
and so the film is released.
To set in action completely the cradle rotation
control and to wrap the bale with the
predetermined number of tours (see schedule on
page 23).
To set cradle rotation speed changing the turn
number of the tractor.
The recommended speed is of 20 tours/min.
DANGER
The cradle speed don’t must higher than 30
tours/min. The max. admited oil capacity is of
20 l/min.
In any case to adjust rotation speed to the bale
conditions: by malformed bales to lower
cradle rotation speed.
fig. 24 – Wrapping
USE & MAINTENANCE MANUAL - 26 -