MASCAR 5100 S, Руководство по эксплуатации и обслуживанию

Страница: 27 / 38

Wrapper 5100
DANGER
To stop immediately the machine if the bale
doesn’t stabilize inside the cradle within the
two first tours.
An “optional” electronic device MC300, can be
used to count the tours necessaries for the bale
wrap.
The needed number of tour has set up with the
computer MC300 and two tours before to reach
this readings , the computer utters an acoustic
and light signal. At the last tour has uttered a
continuous sound, which indicates the end of
wrapping.
STEP 3: Unloading
To align the cradle towards unloading direction
(fig.25).
To do that to go beyond this position with the
rotation and then to set in action the reverse
rotation till the stop.
Before starting, check that there are no
persons, and in particular that there are no
children or animals present close to the
machine, which can be in danger during
unloading.
DANGER
The dangerous area, which has to be
controlled, has to be sufficiently wide to
consider the possible rolling of the bale after
unloading.
fig. 25 – Cradle lift
WARNING
Do not lift cradle before centring of machine.
Proceed with unloading operation (fig.9, lever C)
till the complete lift of the cradle. During this step
the cutting pliers closes automatically, with hold
and cutting of the film till it lay down the foot.
fig. 26 – Unloading
To put the bale on the floor set in action cradle
control in the opposite direction (fig.26).
When the bale is on the floor go ahead a bit with
the tractor to avoid damages to the unloaded bale
and finish the repositioning of the cradle (fig.9,
lever C).
To turn the cradle for 90° to reach the loading
position (fig. 27). Align the cradle through rotation
in the opposite direction.
Now it’s possible to lift the fork to move with the
wrappers near another bale.
WARNING
Don’t set in action the rotation of the cradle
when the fork is lifted more than 30 cm from
the soil or the cradle it isn’t perfectly
horizontal.
USE & MAINTENANCE MANUAL - 27 -