MASCAR 5100 S, Руководство по эксплуатации и обслуживанию

Страница: 25 / 38

Wrapper 5100
- When you begin the new wrapping, after first
two cradle tours, an automatic device
(rearmament) open the cutting pliers through
the lever (F).
DANGER
It is forbidden to open or close manually the
cutting pliers, but it is necessary to execute
these operations exclusively through wrapper
control. To close the cutting pliers you have to
tip the cradle.
To open the cutting pliers are necessary
before two cradle tours.
DANGER
For the first wrapping it’s forbidden to get hold
the film with the cutting pliers, but it is
necessary to fix it at the bale after its
unloading.
4.7 ROLLS DISTANCE SETTING
To adapt the belt section to the bale diameter it is
possible to set the rolls distance.
To have the max motion of the belts it’s important,
that the touch happens along the whole upper
side of the belt.
With bales with a small diameter (120 cm) it’s
possible that touch is concentrated in the centre.
With bales with a big diameter (160 cm), if you
see, that the belt don’t touch in the centre, it’s
advisable to increase the rolls distance, so that
the belts are more stretched and it is possible to
reinstate the touch.
To modify the rolls distance it is necessary to
proceed as hereinafter described (fig.21):
-
To loosen the screws A and B
- To move bearings supports on inside holes
(C) to draw up rolls, or on outside holes (D) to
increase their distance.
- To put and to tighten again the fastening
screws
fig. 21 – Setting rolls distance
4.8 GENERAL CHECKS TO BE
MADE BEFORE WRAPPING
Before starting a wrapping job, carry out the
following checks to censure that you are working
in safe conditions and to censure satisfactory
results:
-
To remove safety block for the fork transport
(fig. 6, page 17).
- To put the wheel on working position.
- To check that every case and protection are
regularly installed.
- To check, that piping of delivery and return of
the oil are correctly connected to the
distributor of the tractor.
- To check that the working area is free of
obstacles and dangerous elements, which
may hinder the regular functioning.
4.9 WRAPPING
WARNING
Before starting, check that there are no persons,
and in particular that there are no children or
animals present close to the machine. Also
ensure that you have complete all-round and
unobstructed visibility.
The machine is provided with an automatic device
for the cradle centring.
To start up it’s necessary to go beyond the cradle
centring angle by rotating the cradle, and then to
reverse the cradle rotation till its stop.
USE & MAINTENANCE MANUAL - 25 -