MASCAR 5100 S, Руководство по эксплуатации и обслуживанию

Страница: 12 / 38

Wrapper 5100
machine, operator can be involved with
possible fatal consequences too.
- During machine operation, it is strictly
forbidden to let any part of your body get near
the moving mechanical parts.
-
It is strictly forbidden to carry people or
animals on the machine and on the tractor.
-
It is strictly forbidden to leave the driver’s seat
whilst the tractor is running.
-
It is strictly forbidden to remove or tamper with
the safety devices.
- Always wear suitable clothing. Never wear
loose clothing or clothes with hems which
could become tangled in the rotating and
moving machine parts.
-
Before starting up the tractor and the
equipment itself, make sure all the safety
devices for the machine’s transport and use
are intact.
- It is strictly forbidden to stand between the
tractor and the machine with the engine
running (Fig. 3), and likewise when the
parking brake is not pulled on and its wheels
are not blocked with suitably sized chocks.
fig. 3 – Danger zone
-
Before you leave the tractor unmanned,
switch off the engine, apply the parking brake
and remove the ignition key from the control
panel.
-
Before starting, check that there are no
persons, and in particular that there are no
children or animals near the machine. Also
ensure that you have complete all-round and
unobstructed visibility.
-
All transport and moving operations outside
the working area must be carried out with the
machine in its transport position.
-
Before starting, ensure that the support foot
has been removed from under the machine
and that the machine has been correctly
installed and set. Also ensure that all
components subject to wear or corrosion are
in perfect working condition.
-
Always keep grease and oil out of the reach
of children.
-
Always read warnings and instructions given
on the containers.
-
Avoid skin contact with dangerous
substances.
-
Always wash thoroughly after using the above
mentioned products.
- Maintenance, setting and preparation for
use must only be carried out with the
machine on the ground and supported by
its support foot, with the tractor turned off
and secured in position and with the key
removed.
-
When additional equipment is connected to
the tractor, this changes the weight
distribution over the axes. It is therefore
advisable to fit ballast weights onto the front
of the tractor in order to balance out the
weights over the axes. Check that the tractor
handles safely with the weight transferred by
machine through the 3 point support
connection. In case of doubt, contact the
tractor Manufacturer.
-
It is very important that you bear in mind that
the tractor’s road holding, steering and
braking capacities can be substantially altered
by towed or carried equipment.
-
When taking corners with or without the
machine loaded onto the tractor, be careful of
centrifugal forces acting on points different
from the centre of gravity.
-
Connect the machine as described to a tractor
with a suitable power output and
configuration, using the correct connection
equipment (tow ring or support), in
compliance with legislation.
-
Always be particularly careful during machine
equipment connection and disconnection.
-
Never exceed the maximum load limits per
axle or the maximum total vehicle weight limit.
Always respect road transport regulations and
the highway code.
- Any additional accessories to be transported
must also be fitted with suitable signalling and
safety devices.
USE & MAINTENANCE MANUAL - 12 -