81
Number (4):
wireless routers must use the same setting.
Associated Clients Click Show Active Clients. An Active Wireless
(5):
Client Table will pop up. You can see the status
of all active wireless stations that are
connecting to the access point.
MAC address
Input the MAC address of the other wireless
1 to 4 (6 - 9):
routers.
Security
Click to set security settings for this connection
Setting (10):
(go to 2-7-3 Wireless Security for details).
2-7-1-6 Setup procedure for Universal Repeater
In this mode, the router can act as a wireless repeater — serving as
a Station and AP at the same time. It can use the Station function to
connect to a Root AP and use the AP function to service all
wireless stations within its coverage.
2.4GHz Universal Repeater Settings
1
2
3
4
5
7
6
NOTE: For Repeater Mode, this router will demodulate the received
signal, checking if this signal is noise for the operating network, then
have the signal modulated and amplified again. The output power of
this mode is the same as that of WDS and normal AP mode.
Содержание 525541
