86
wireless router can connect.
CTS Protect (10): Enabling this setting will reduce the chance of
radio signal collisions between 802.11b and
802.11g/n wireless access points. It’s
recommended to set this option to Auto or
Always. However, if you set it to None, your
wireless router should be able to work fine.
Tx Power (11):
You can set the output power of the wireless
radio. Unless you’re using this router in a really
big space, you may not have to set output
power to 100%.
This will enhance security
(distant malicious / unknown users will not be
able to reach your router).
WMM (12):
Short for Wi-Fi MultiMedia, it will enhance the
data transfer performance of multimedia
contents when they’re being transferred over a
wireless network.
If you don’t know what it is
or aren’t sure if you need it, it’s safe to set
this option to Enable.
After you finish these wireless settings, click Apply and the
following message will be displayed on your Web browser:
Click Continue to go back to the setup menu or to continue to other
setup procedures, or click Apply to reboot the router so the settings
will take effect (wait about 40 seconds while router is rebooting).
Содержание 525541
