Makino V55, Руководство по обслуживанию

Страница: 498 / 568

A - 30
118 PARENTHESIS
NESTING ERROR The nesting of bracket exceeds the upper limit (quin-
tuple).
119 ILLEGAL ARGUMENT The SQRT or BCD argument is negative, and other
values than 0 to 9 are on each line of BIN argument.
122 DUPLICATE MACRO
MODAL- CALL The macro modal call is specified in double.
123 CANNOT USE
MACRO COMMAND
IN DNC
Macro control command is used during DNC opera-
tion.
124 MISSING END
STATEMENT DO - END does not correspond to 1:1.
125 FORMAT ERROR IN
MACRO <Formula> format is erroneous.
126 ILLEGAL LOOP NUM-
BER In DOn, 1£ n £3 is not established.
127 NC, MACRO STATE-
MENT
IN SAME BLOCK NC and custom macro commands are confused.
128 ILLEGAL MACRO
SEQUENCE NUM-
BER The sequence number specified in the branch com-
mand was not O to 9999. Or, it cannot be searched.
129 ILLEGAL ARGU-
MENT ADDRESS An address not allowed in <Argument Designation>
is used.
130 ILLEGAL AXIS OPER-
ATION An axis control command was given by PMC to an
axis controlled by CNC. Or an axis control command
was given by CNC to an axis controlled by the PMC.
131 TOO MANY EXTER-
NAL ALARM MES-
SAGES Five or more alarms have generated in external
alarm message.
132 ALARM NUMBER
NOT FOUND No alarm No. concerned exists in external alarm
message clear.
133 ILLEGAL DATA IN
EXT. ALARM MSG Small section data is erroneous in external alarm
message or external operator message.
135 ILLEGAL ANGLE
COMMAND The index table indexing positioning angle was
instructed n other than an integral multiple of the
value of the minimum angle.
136 ILLEGAL AXIS COM-
MAND In index table indexing, another axis was com-
manded together with the B axis.
P/S Alarms (continued)
No. Message Contents