Makino V55, Руководство по обслуживанию

Страница: 499 / 568

4V2A1563 (E) A - 31
137 M-CODE & MOVE
CMD IN SAME BLK A move command of other axes was specified to the
same block as M code related to spindle indexing.
138 SUPERIMPOSED
DATA OVERFLOW The total distribution amount of the CNC and PMC is
too large during superimposed control of the
extended functions for PMC axis control.
139 CAN NOT CHANGE
PMC CONTROL AXIS An axis is selected in commanding by PMC axis
control.
141 CANNOT COMMAND
G51 IN CRC G51 (Scaling ON) is commanded in the tool offset
mode.
142 ILLEGAL SCALE
RATE Scaling magnification commanded is other than 1 -
999999.
143 SCALED MOTION
DATA
OVERFLOW The scaling results in move distance, coordinate
value and circular radius exceed the maximum com-
mand value.
144 ILLEGAL PLANE
SELECTED The coordinate rotation plane and arc or tool offset
C plane must be the same.
145 ILLEGAL CONDI-
TIONS IN POLAR
COORDINATE
INTERPOLATION The condition are incorrect when the polar coordi-
nate interpolation starts or it is cancelled.
1. In modes other than G40, G12.1/G13.1 was spec-
ified.
2. An error is found in the plane selection. Parame-
ters 5460 and 5461 are incorrectly set.
146 IMPROPER G CODE G code which cannot be specified in the polar coor-
dinate interpolation mode was specified.
148 ILLEGAL SETTING
DATA Automatic corner override deceleration rate is out of
the settable range of judgement angle Modify the
parameters 1710 to 1714.
199 MACRO WORD
UNDEFINED Macro word undefined.
200 ILLEGAL S CODE
COMMAND In rigid tap, S value is not specified or is out of
range.
201 FEEDRATE NOT
FOUND IN RIGID TAP In the rigid tap, no F value is specified.
202 POSITION LSI OVER-
FLOW In the rigid tap, spindle distribution value is too large.
203
PROGRAM MISS AT
RIGID TAPPING In the rigid tap, position for a rigid M code or an S
command is incorrect.
204 ILLEGAL AXIS OPER-
ATION In the rigid tap, an axis movement is specified
between the rigid M code block and G84 (G74)
block.
P/S Alarms (continued)
No. Message Contents