en
|
24
|
CWL-20E
Maintenance and Inspection
12.8
Control box removal
The
electronics enclosure can be removed from the lift.
Remove the screws holding the lid and carefully lift the
lid a few inches from the box being careful so that the
LEDs’ wires do not get damaged. Do not allow the lid to
hang by the LEDs’ wires. Take note of where and how
everything is connected so that they can be properly
reconnected during reinstallation. Taking a picture for
reference may be helpful. The LEDs’ wire harness can be
disconnected from the control board if desired or
necessary. Remove the nuts holding the electronics
enclosure to the lift and disconnect the wire connectors
from the board. Gently feed the wiring harnesses out of
the bottom of the box while lifting the box off of the lift.
Reattach the lid if the electronics enclosure is to be
stored, transported, or shipped. Ensure the wiring
harnesses and hardware are connected correctly when
the electronics enclosure is reinstalled.
Fig. 18: Control box removal
Fig. 19: Control box connections
1
Primary input connection
2
E-stop connection
3
Primary output connection
