MAHLE ACX150, Руководство пользователя

Страница: 17 / 198

EN | 17 | ACX150/250 | Commissioning
© MAHLE
Power mains
connection Vehicle A/C system
connections
8.1.1 Positioning and connection
HANDLING: During handling, the
minimum devices required for
correct handling shall be ensured,
as provided for by accident
prevention provisions.
POSITIONING: Place the unit in a
stable place. The location must be
well ventilated, with a good rate of
change of air. The unit must be
located at least 10 cm from any
potential obstacles to its internal
ventilation. Keep the unit away
from rain and excessive humidity
as they can irreparably damage it.
In addition, the equipment must
never be directly exposed to the
sunrays or to excessive dust.
INSTALLATION: the unit must be
installed by a specialised
technician in scrupulous
observance of in accordance with
electrical engineering principles.
The use of the equipment in
explosive atmosphere is
forbidden.
CONNECTIONS: since the unit is
connected to the main power
supply, it must be properly
grounded with its power plug
GND pin. Failure to ground the
unit can damage it and
constitutes a risk of fatal injury to
the operator. Position the unit so
that the power plug is easy for the
operator to access.
ATTENTION: Leave the quick
coupling taps closed when the
unit is not in use and at the end of
vehicle service operations.
8.2 Initial verification
Execute the following actions in sequence
by following the display guided procedure
and the illustrations on the screen of the
equipment:

Refrigerant weight check

Oil weight check

First tank filling
It is possible to interrupt the initial check
and print a report with the equipment
printer in which the checking status is
reported. The equipment cannot operate
in automatic mode until all the steps of
the initial check have been completed.
CAREFULLY ABIDE BY
THE FOLLOWING
INSTRUCTIONS TO
AVOID DANGER TO
PERSONS, THE
DISCHARGE OF
REFRIGERANT IN THE
ATMOSPHERE