Maintenance Manual
MAN-00
167
XYLO
mHawk
February 2012/ Rev1
The repair methods given by the manufacturer in this document are based on the technical specifications
,
current at the time of release. The methods may be modified as a result of changes introduced by the
manufacturer in the production of the various component units and accessories from which the vehicles are manufactured. The reproduction, translation, transmission, in part of
or
whole of the present document,
are prohibited without the prior written consent of Mahindra & Mahindra Ltd. The use of this document by any person other than the trained personnel, at the Authorized Service Centre of Mahindra & Mahindra
Ltd., will amount to unauthorized use and shall be liable for penalty/prosecution
© 2012 Mahindra & Mahindra Ltd.
Programming of the INT delay time is as follows -
•
Turn the wiper stalk to position C, wiper will start wiping
•
Turn the wiper stalk to OFF position, before wiper starts second wipe
•
Turn the wiper stalk to position C again after the required delay and the same delay will be
programmed.
•
On keeping wiper ON position C, the wiper will wipe again with the programmed delay.
Low Speed Wiping
Push the wipe control stalk down to the
position D to operate the wiper at a fixed low
speed.
High Speed Wiping
Push the wiper control stalk down to position E
to operate the wiper at a fixed high speed.
Wipe/Wash
Pull/Lift the wiper control stalk towards the steering wheel from any position to activate wipe/wash
function. Washer fluid is sprayed on the front windshield and the wipers wipe the windshield 3 times
after the washer spray is stopped and wipe once after 5 sec.
Rear Wiper
Rotate the outer rotary switch on the wiper
control stalk to align the “dot” on the switch to
the “1st detente” position on the wiper stalk to
operate the rear wiper.
Auto-rear Wiping
With the front wipers ON and rear wipers OFF,
engaging the reverse gear activates the rear
wiper.
Page 53