5 - Configuration
DynaPro Go| Handheld PIN Pad Device with MSR/Contact/Contactless | Installation and Operation Manual
Page 24 of 60 (
D998200129-10
)
5.1.1
LCD Display Brightness Auto Mode
When the display brightness is set to
Auto
mode, the device adjusts the LCD backlight brightness
automatically based on ambient light detected by the light sensor (see section
).
The brightness levels the device will select are shown in
. When the device is in
Auto
mode,
the key combination to manually set LCD brightness is not available.
Table 5-2 - LCD Display Brightness Levels
Light Level
LCD Brightness Level
High
Maximum (99%)
Medium
High (75%)
Low
Medium (60%)
Very Low
Low (45%)
5.1.2
LCD Display Brightness Manual Mode
When the display brightness is set to
Manual
mode, the device keeps the LCD backlight brightness at a
constant level the user can select. The factory default is
High
(75% brightness). To change the constant
brightness level, press
Left Function Key
5
2
3
Right Function Key
to show the
Adjust LCD
screen.
Select the desired brightness by pressing the
1
key to decrease and the
3
key to increase, then press the
Enter
key to save the change. To exit without saving changes, press the
Cancel
key or wait 10 seconds
for the device to return to the
Welcome
screen.
