4 - Installation
DynaPro Go| Handheld PIN Pad Device with MSR/Contact/Contactless | Installation and Operation Manual
Page 20 of 60 (
D998200129-10
)
4.2
About Software
In any solution, DynaPro Go is connected to a host, which must have software installed that knows how
to communicate with the device, and which is capable of processing transactions. To set up the host to
work with DynaPro Go, follow the installation and configuration instructions provided by the vendor of
the host or the host software. For information about developing custom host software, see section
4.3
About Connecting to a Host
The following sections provide steps for connecting DynaPro Go to a host via the various available
physical connection types.
4.3.1
How to Connect DynaPro Go to a Computer Host or Charger via USB
Figure 4-1 - Connecting DynaPro Go to a Computer or USB Charger
To connect DynaPro Go to a host computer or charger using the Micro USB port, follow these steps:
1)
In any order:
•
Connect the small end of the USB cable to DynaPro Go as shown in
•
Connect the large end of the USB cable to the charger or to the host computer’s USB port.
2)
As soon as DynaPro Go starts receiving power through USB, it will automatically power on.
3)
If you want DynaPro Go to communicate with the host via USB (as opposed to merely using it as a
power source to charge the battery), make sure it is configured to use the USB connection. See
5.3 How to Change the Active Connection
4)
If the specific DynaPro Go serial number you are connecting has not been connected to the host
before, the Windows system tray on the host will report it is
Installing device driver software
.