M/A-Com P5100 Series, Руководство по установке

Страница: 62 / 100

MM102225V1, Rev. B
61
STEPS ACTION MISCELLANEOUS
3.
Check the rear panel of the Cisco 3600
access server and observe whether the
Carrier Detect LED is lit and the
LOCAL and REMOTE ALARM
LED’s are off.
4.
Connect the PC to the CON port of the
Cisco 3600 access server. This connector
is located on its front panel.
5.
Using address information given in the
regional IP Address Excel spreadsheet,
ping the MIS1 and MIS2 servers located
in the ROC. Commands and responses
are shown to the right.
buck40sas>ping 10.136.10.21
19
Sending 5, 100-byte ICMP Echoes to
10.136.8.10, timeout is 2 seconds:
!!!!!
Success rate is 100 percent (5/5), round-trip
min/avg/max = 8/8/12 ms
buck40sas>ping 10.136.10.21
Sending 5, 100-byte ICMP Echoes to
10.136.8.11, timeout is 2 seconds:
!!!!!
Success rate is 100 percent (5/5), round-trip
min/avg/max = 8/12/24 ms
buck40sas>
6.
Record the success or failure on
worksheet
20
.
19
" Buck40 ", where used in this manual, is only an example of the applicable code.
20
Refer to APPENDIX L - RECORDED DATA SHEET.