M/A-Com P5100 Series, Руководство по установке

Страница: 11 / 100

MM102225V1, Rev. B
10
The safety guidelines and precautions presented in this manual do not replace M/A-
COM's specific requirements. The primary responsibility for health and safety standards,
practices and guides lines in a M/A-COM project lies with the
E nvironmental, H ealth &
S afety ( EHS ) department.
All M/A-COM managers, supervisors, or subcontractors responsible for work associated
with OpenSky equipment must be completely familiar with and prepared to comply with
all applicable EHS guidelines and requirements. Although M/A-COM's policy requires
that all contractors and visitors must be adequately trained prior to working on any M/A-
COM project, this does not mean M/A-COM is responsible for conducting or providing
this training.
The following safety precautions must be observed during all phases of operation,
service, and repair of this product. Failure to comply with these precautions or with
specific warnings elsewhere in this manual violates safety standards of design,
manufacture, and intended use of the product. M/A-COM assumes no liability for the
customer’s failure to comply with these standards.
1. SAVE THIS MANUAL - It contains important safety and operating instructions.
2. Before using this equipment, please follow and adhere to all warnings, safety and
operating instructions located on the product and in the manual.
3. DO NOT expose equipment to rain, snow or other type of moisture.
4. Care should be taken so objects do not fall or liquids do not spill into the equipment.
5. DO NOT expose equipment to extreme temperatures.
6. DO NOT use auxiliary equipment not recommended or sold by M/A-COM. To do so
may result in a risk of fire, electric shock or injury to persons.
7 GROUND THE EQUIPMENT -To minimize shock hazard, the station equipment
cabinet must be connected to an electrical ground.
IF the equipment supplied is equipped with three-conductor AC power cords, these
power cords must be plugged into approved three-contact electrical outlets with the
grounding wires firmly connected to an electrical ground (safety ground) at the
power outlet. The power cords must also meet
I nternational E nergy C ommission
(IEC) safety standards.
8. To reduce risk of damage to electrical cords, pull by plug rather than cord when
disconnecting a unit.
9. Make sure all power cords are located so they will not be stepped on, tripped over or
otherwise subjected to damage or stress.
10. An extension cord should not be used unless absolutely necessary. Use of an
improper extension cord could result in a risk of fire and electric shock. If an
extension cord must be used, ensure:
a. The pins on the plug of the extension cord are the same number, size, and shape
as those of the plug on the power supply.
b. The extension cord is properly wired, in good condition, and
c. The wire size is large enough for the AC ampere rating of unit.