M/A-Com Orion, Руководство оператора

Страница: 43 / 80

43
stored in this list but the individual's unit ID is known, it can be entered
directly from the keypad.
2. Press the PTT button; the radio performs the necessary signaling to obtain
a communication channel. When the signaling is complete and the radio is
clear to transmit,
TX indicator turns ON and the channel access tone
sounds. Line one shows the called individual's name if found in the list of
stored individuals or ID followed by the logical ID number of the unit
being called. The message
* INDV * displays on line two. Proceed with the
message.
SCAT™ OPERATION
A SCAT (Single Channel Autonomous Trunking) System operates with same
set of features as a standard EDACS system. The only significant user change
relates to the
BSY indicator. Since only one channel, operating as both control
and working channel, exists in a SCAT System, the BSY indicator will be ON
when the SCAT channel is in the working channel mode. When the
transmission on the channel is completed, the indicator turns OFF and
indicates the return of SCAT control channel signaling.
TELEPHONE INTERCONNECT CALLS
Receiving A Telephone Interconnect Call (Trunked Mode
Only)
Receiving a telephone interconnect call is identical to receiving an individual
call. See the DTMF Overdial Operation section if access to services requiring
"over-dial" is needed. Overdial operations are available for any special call
whether it is an individual call or a telephone interconnect call.
Sending A Telephone Interconnect Call (Trunked Mode
Only)
Use the following procedures to initiate and complete a Telephone
Interconnect call:
1. To select a previously stored phone number, select phone call mode from
the menu; press
p
and use the RAMP control
,
or
.
to scroll
through the list of stored phone numbers. The selection mode rules apply.
While in the phone call list, the
m
key will toggle the display between
the phone call name and the phone call number. If the phone number is not
stored in this list but the phone number is known, it can be entered directly
from the keypad. If necessary, a pause can be entered by pressing and
holding
0-9 , * , or # until an underscore appears in the display.