47
•
Declaring an emergency (not to be used unless an actual emergency
condition exists). Alert tone will sound.
•
Pressing
the
o
button (System Model) or
O
(Scan Model)
(pre-programmed). Alert tone will sound.
•
Selecting the function using the m button (pre-programmed).
•
Pressing the ND button (System Model Only) (pre-programmed).
Data On Operation
The data state is enabled by one of the following (depending on how it was
disabled). "DATA ON" will be displayed top line of display for 2 seconds
then the display returns to normal.
•
Replacing the microphone into the hook switch (going on-hook).
Only valid if the data OFF operation was entered by removing the
microphone from the hook switch (going OFF-hook).
•
Pressing the ND key toggles data state on or OFF.
•
Clearing an emergency but valid only if emergency caused data OFF
operation.
Exiting Data Calls
Under normal conditions, the radio enters the scan lockout mode and returns
to the control channel after completion of a data call (transmit or receive). If,
during a data call, one of the following conditions occurs, the data call is
immediately terminated and the radio performs the desired function:
•
PTT
activated.
•
PTT in Public Address mode.
•
Emergency declared by pressing the pre-programmed emergency
button.
•
A group or system change.
Scan Lockout Mode
Following the transmission or reception of a data call, if scan is enabled,
scanning will stop temporarily (duration pre-programmed). During this time
the scan LED will flash to indicate that scan is enabled but temporarily
suspended. This mode is normally exited when the pre-programmed time
expires; however, the following actions will terminate the scan lockout mode
before the timeout is completed.
Содержание Orion
Страница 1: ...Operator s Manual LBI 38888 Rev N Mar 05 Orion Mobile Radio ...
Страница 79: ...NOTES 79 ...