2. Installation
MODEX-F15-OPTS, MODEX-F15-OPTM series – User's Manual
8
2.1.2. Truss Mounting (with Mounting Bracket V2)
Step 1.
Fasten the mounting bracket on the side
of the unit with the provided screws.
Step 2.
Use a bolt to attach a standard clamp.
(The clamp is not supplied with the
device.)
Step 3.
Mount the unit on the truss with the
clamp.
2.1.3. Through Furniture Mounting (with Mounting Bracket V2)
To get a good result, the thickness of the board
should not exceed 25 millimeters.
Step 1.
Cut a suitable hole in the board.
Step 2.
Attach the mounting bracket on the side
of the unit with the provided screws.
Step 3.
Mount the unit on the board.
Step 4.
Loosen the screws a little on the bracket
and adjust the unit to line up with the front
of the board.
The chapter is about the installation of the device and connecting to other
appliances, presenting also the mounting options and further assembly steps:
2.1.
Mounting Options
Devices can be mounted in several ways, depending on the application.
Besides using with rack shelf, a mounting bracket is available which
offers easy mounting on truss systems with standard clamps. The
bracket can be also used for building the unit into the furniture.
ATTENTION!
Pay attention to the ventilation holes when designing
the system especially when the extender is built into/under furniture.
Side ventilation holes must not be covered. If a MODEX extender is
installed in a closed space, the designer shall provide satisfactory
ventilation to prevent excessive heat build-up inside.
2.1.1. Rack Shelf Mounting (with 1U high Rack Shelf)
Step 1.
Turn the unit upside down.
Step 2.
Put the rack shelf upside down on the unit, and position it to get
the mounting holes aligned.
Step 3.
Fasten the unit on the rack shelf with the provided screws.
Step 4.
Mount the rack shelf in the rack.
INFO: The MODEX transmitter and receiver units are half-rack sized.
Î
Î
