LightPointe AireLink 60, Инструкция по установке и эксплуатации

Страница: 79 / 133

AireLink

60 Installation and User Manual Rev. D System Installation
Page 79
Figure 5-18: Typical AireLink 60 MX/LX RSSI vs. Distance Charts for stand distance settings
9. After maximizing the RSSI signal levels on both sides of the link, do not forget tightening the
Elevation and Azimuth Locking Bolts (see Fig. 5-14 and Fig. 5-15).
10. Disconnect the voltmeter from the RSSI signal connector. Use web browser to switch the
system from ALIGNMENT MODE to DATA MODE operation. Failing to perform this step
will result in the system rebooting in ALIGNMENT MODE when the system is power
cycled. After performing this step, the
ALIGN LED on the user panel should be off.
11. When looking at the user panel (see Fig. 5-19 the following LEDs should be on:

POWER LED

RF ON

RF SYNCH
Depending on the status of the networking connections additional port status LEDs might be lit,
too.
Figure 5-19: Default User Panel status after successful alignment
12. When using the external 1 foot or 2 foot dish antennas, the minimum distance between the
antennas in
Standard distance mode (see RF Link menu on page 74) is 325 and 550 meters,
respectively. If the system is installed over a shorter distance, please change the distance
setting to
Short or Very Short to avoid receiver saturation which occurs around -31 dBm. The
table below shows the distance ranges for Standard , Short and Very Short distance settings.