LightPointe AireLink 60, Инструкция по установке и эксплуатации

Страница: 54 / 133

AireLink

60 Installation and User Manual Rev. D Recommended Software Pre-Configurations
Page 54
Step 4
To change/modify basic IP settings from the original default settings
(IP:192.168.1.10, Subnet mask: 255.255.255.0, Gateway: 192.168.1.1), please
use/type the following command following the
AireLink 60(configure)#
command prompt:
Change/set new IP address:
Command:
airelink60(config)# interface management ip mynewIP
Note: When management port IP address is changed, the new setting will occur
immediately. At that point one will need to re-connect to the CLI via Telnet and
using the new IP address setting.
Change/set new Network Mask:
Command:
airelink60(config)# interface management netmask mynewmask
Change/set new Default Gateway:
Command:
airelink60(config)# interface management gateway mynewgateway
Step 5
At this point the user can/might want to also change the login password for the
CLI interface and the web browser. These passwords can be different. It is
important to write them down and store in a secure place to avoid problems in
the future.
Change/set new CLI password:
Command:
airelink60(config)# password cli mynewclipassword
Change/set new WEB BROWSER password:
Command:
airelink60(config)# password web mynewwebpassword