LightPointe AireLink 60, Инструкция по установке и эксплуатации

Страница: 76 / 133

AireLink

60 Installation and User Manual Rev. D System Installation
Page 76
c. After starting the application, the software will automatically scan for AireLink systems.
To find the system the line-of-sight distance between the phone/tablet and the AireLink
system should not be more than 300 feet (100 meters). Distances will be shorter in case
of an obstructed view. After successful discovery, click the AireLink system you would
like to connect to. When asked, please enter the default passcode 0000 to finalize the
connection. (
Note: This code can be changed later using the web browser interface to
preclude non authorized system access.) Open the application RADIO tab and observe
the RSSI value.
4. Verify that the RF ON LED is lit (green) on both radio heads.
5. Most likely at this point there is no connectivity established between the radios and RF SYNCH
LED will be off. Depending on the status and wiring of additional networking connections there
might be other data port LEDs lit, too. However, these are not essential for the alignment
process and the system can be aligned without an active network connection being present.
6. Look through the Alignment Sight Tool and turn the Elevation and
Azimuth Adjustment Screws until the opposite antenna location
shows in the middle of the Alignment Sight Tool. The inside of the
tool is reflective and this helps to center the remote antenna site
location. In case the opposite side is too far away to be clearly
seen, please use binoculars to find an easy recognizable landmark
close to the opposite antenna side. Perform the same procedure
at both sides.