Liangzi Power UTV1000-3, Руководство по обслуживанию

Страница: 29 / 184

2.PERIODIC MAINTENANCE
2
- 19
the moving parts. The engine oil pressure test should be done with a warm engine 90
℃
and the
recommended oil.
Remove left and right seats, gear shift
handle and engine shield.
Remove the oil pressure switch wire
connector and switch on the right of
engine.
Install oil pressure gauge and adapter hose.
Start engine on idle speed. The engine oil
pressure should be within the following values.
Remove oil pressure gauge and adapter hose.
Installation oil pressure switch to 12 N.m
and the oil pressure switch wire
connector.
Install engine shield gear shift handle
globe and left and right seats.
SUSPENSION SYSTEM
Lubricate both suspension arms with lithium-soap based
grease. There are two grease fittings on each suspension
arm. Check operation and for leakage.
Grease fitting location
Lubricate rear knuckles with lithium-soap based grease.
There are two grease fittings on each rear knuckle.
Oil pressure 1250 RPM 6000 RPM
Minimal 70kPa 300kPa
Nominal 150kPa 350kPa
Maximal 250kPa 450kPa