Liangzi Power UTV1000-3, Руководство по обслуживанию

Страница: 122 / 184

4. COOLING SYSTEM
4-
10
shaft and intermediate shaft.
NOTE: Never use oil in the press fit
area of the oil seal and rotary seal.
Use the oil seal pusher and the installer
Handle to install inner oil seal.
1. Handle
2. Pusher
Apply MOLYKOTE inside lips oil
seal when installing the oil seal on
the pusher, make sure sealing lip
points outside.
Push inner oil seal in place.
1. Inner oil seal
2. Installer handle with oil seal
pusher
Slide water pump shaft with the
new rotary seal into crankcase.
To properly install water pump shaft
with rotary seal, use the rotary seal
installer.
Use a plastic hammer and drive
rotary seal into crankcase.
From engine drive shaft opening.
Insert thrust washer pump shaft in
crankcase.
Using a flashlight and a mirror,
position the shaft hole so that pin
can be installed.
Position pin between your fingers,
push in water pump shaft to fully
expose hole then install pin.
Position pin equal distance out of
shaft hole so gear can be installed.
Install water pump shaft gear.