Liangzi Power UTV1000-3, Руководство по обслуживанию

Страница: 123 / 184

4. COOLING SYSTEM
4-
11
NOTE: Ensure gear properly snaps
on pin.
A screwdriver may have to be used
to push gear in place.
Use a snap ring pliers and install a
new retaining ring on pump shaft
end.
CAUTION : Never use the retaining
ring a second time. Always install a
new one.
After installation, water pump shaft
with rotary seal must rotate freely.
Carefully push in water pump gear
while turning to mesh with the inner
drive gear.
1. Water pump gear
2. Inner drive gear
Tighten Screws of the water pump
housing crosswise.
Refill all coolant.
Water temperature sensor
Removal and Inspection
Disconnect and remove sensor from
rear cylinder head.
Place sensor into container with cooling
liquid and slowly heat it to measure its
resistance. Temperature meter cannot
get in contact with container bottom.