Liangzi Power UTV1000-3, Руководство по обслуживанию

Страница: 27 / 184

2.PERIODIC MAINTENANCE
2- 17
Bleed
screw
Unscrew bleed screws on top of
thermostat housing.Both cylinders must be bled.
Fill up the radiator with coolant, when the coolant
comes out by the thermostat housing hole, install the
bleed screws with its gasket ring and torque to 10 N.m.
Refill coolant tank up to upper level mark. Install the
coolant tank cap and the radiator cap.
Run engine until radiator fan opens then stop engine.
When engine has completely cooled down, recheck
coolant level in radiator and coolant tank, Top up if
necessary
WHEELS
Lift wheels up at horizontal position
and ensure no load to each wheel.
Shake wheels to left and right to see
whether their connecting parts are
installed tightly and check whether they
can be swung.
No adequate tightening: → tightening
Swing: → replace rocker arm
Tire pressure
I
mproper tire pressure will lower
comfort of operation and driving and
may lead to wear to side edges of tires.
Front wheel Rear wheel
Recommended
pressure
110kPa
(1.12kgf/cm
2
)
110kPa
(1.12kgf/cm
2
)
Dimension of tire 29×8-15 29×10-15