Liangzi Power UTV1000-3, Руководство по обслуживанию

Страница: 167 / 184

10. ELECTRICAL SYSTEM
10- 7
IGNITION SYSTEM
Ignition coil
Primary peak voltage of ignition coil
Z Remove the spark plug cap as
shown in the right figure. Install the
new spark plug to the cap. The
cylinder is connected to grounding.
Z Connect the multimeter and the
peak voltage adapter as follows:
+Probe: Green wire or grounding
wire
-Probe: Black / yellow wire
NOTE:
Z
Make sure the battery voltage ≥ 12V. The ignition coil wires are connected.
Z When using multimeter and the peak voltage adapter, please refer to the user manual.
Z Move the gear to the neutral position, turn on the ignition device.
Z Press the start button and crank the engine for a few seconds. Then measure the primary peak
voltage of the ignition coil;
Z Repeat the steps above for several times. Measure the maximal value of the primary peak
voltage.
Set the multimeter at the AC voltage position.
Primary peak voltage of ignition coil:
≥150V