Lexmark X95 series, Руководство по обслуживанию

Страница: 931 / 1182

Repair information
4-437
7558- xxx
Go Back
Previous
Next
15. Move the bushing (J) inward in the direction of the arrow (4) to remove it from the tray.
16. Move the tray lift shaft assembly (B) outward in the direction of the arrow (5) to remove it from the tray.
17. Move the tray lift shaft pulley (C) inward in the direction of arrow (6) to detach the front cables (K).
18. Remove the two e-clips securing the small cable pulleys (E) on the top front of the HCF media tray.
19. Remove the two small guides (F) and the two small pulleys (E).
20.
Remove the e-clip securing the large pulley (G) to the frame assembly.
21.
Remove the large guide (H) and the large pulley (G).
22.
Remove the two front cables (K) from the bottom plate (I).
Note:
Before re-installing:
–
It is recommended that all four cables be replaced together.
–
When fitting the cables (D) and (K), ensure they are not twisted or kinked.
–
Route the cables properly, as shown.
–
Be sure to replace the washer on the front of the tray lift shaft assembly.
HCF media long edge guide assembly removal
1.
Pull out the HCF media tray.
2.
Remove the e-clip securing the media long edge guide assembly (A) to the HCF media tray.
( 6)
( 5)
( 4)
C
B
Washer
J
C
K
I
K
G
H
F
E