Lexmark X95 series, Руководство по обслуживанию

Страница: 360 / 1182

3-8
Service Manual
7558- xxx
Go Back
Previous
Next
ADF Edge Erase
The value of this setting determines the size in millimeters of the “no-print” zone around an ADF scan job.
To change this setting:
1. From the Configuration Menu, navigate to
ADF Edge Erase
.
2. Touch or to change the setting.
3. Touch
Submit
to save the setting, or touch
Back
to return to the Configuration Menu without saving any
changes.
Automatic Alignment Adjust Calibration
This setting is for performing Toner Patch Sensing (TPS):a diagnostic mechanism that automatically adjusts the
printer’s toner density. When TPS executes, the printer generates toner patches on the belt and then uses these
to calculate if necessary, the appropriate amount of adjustment.When an event initiates a TPS operation, the
device performs a toner density calibration.
To change this setting:
1.
From the Configuration Menu, navigate to
Automatic Alignment Adjust Calibration
.
2.
Touch or to change the setting.
3.
Touch
Submit
to save the setting, or touch
Back
to return to the Configuration Menu without saving any
changes.
Automatically Display Error Screens
To change this setting:
1.
From the Configuration Menu, navigate to
Automatically Display Error Screens
.
2.
Touch or to change the setting.
3.
Touch
Submit
to save the setting, or touch
Back
to return to the Configuration Menu without saving any
changes.
Black Only Mode
This mode enables a user to force the printer to always print color content in grayscale. Turning this setting
On
is equivalent to setting Print Mode to
Black Only
; the printer will ignore any PJL or datastream commands that
attempt to change the Print Mode setting. If this setting is
Off
, then the printer will print color content as normal.
To change this setting:
1.
From the Configuration Menu, navigate to
Black Only Mode
.
2.
Touch or to change the setting.
3.
Touch
Submit
to save the setting, or touch
Back
to return to the Configuration Menu without saving any
changes.
Booklet Adjustments
The Booklet Adjustment menu enables the user to correct any folding overlap or skew overlap errors that occur
when the device performs folding or saddlestitch finishing on a job that uses a specific combination of media
size and total number of sheets (example: a 2-sheet, Letter-sized job).
Clear Custom Status
Executing this operation erases any strings that have been defined by the user for the Default or Alternate
custom messages.