Lexmark X95 series, Руководство по обслуживанию, Страница: 449 / 1182

Diagnostic aids
3-97
7558- xxx
Go Back
Previous
Next
Determining tamper home position
When the sensor (lower media exit) turns high (+5 V dc) (light receiving), the front and rear tamper motors on
the compiler unit assembly are activated, and the front and rear tampers start moving.
The front tamper home position is determined when the front tamper enters the sensor (front tamper HP)
sensing area.
In the same way, the rear tamper home position is determined when the rear tamper enters the sensor (rear
tamper HP) sensing area.
Tamping
Tamping is executed after a preset time has passed after the sensor (compiler media present) turns high
(+5 V dc) when media is detected on the compiler unit assembly.
Offsetting
Offsetting is an operation to shift the position of media to be ejected to the stacker media bin so that boundaries
between media units (sets of media, job units, etc.) can be easily recognized.
Offsetting is executed for staple positions:
• During front stapling (corner)—Shifts stapled sheets using the front tamper by 20 mm to the rear side before
ejecting them to the stacker media bin
• During rear stapling (corner/straight)
– For media with a width of 216 mm or more [rear staple (corner)]—Shifts stapled sheets using the rear
tamper by 20 mm to the front side before ejecting them to the stacker media bin
–
For media with a width of less than 216 mm [rear staple (straight)]—Shifts stapled sheets using the front
tamper by 9 mm to the rear side before ejecting them to the stacker media bin.
During dual stapling:
• Shifts stapled sheets using the front tamper by 9 mm to the rear side before ejecting them to the stacker
media bin.
• Offsetting is not executed (0 mm) for small media.
Functions of compiler unit assembly sensors/motors
• Sensor (compiler media in)
–
A photo-interrupter sensor that detects whether media is present or not on the compiler unit assembly.
–
When media is detected, the actuator leaves the sensing area, which turns the sensor to high (+5 V dc)
(light receiving).
• Sensor (front tamper HP)
– A photo-interrupter sensor that detects the front tamper home position.
– When the front tamper comes to the home position, it enters the sensor’s sensing area, which turns the
sensor to high (+5 V dc) (light blocking).
• Sensor (rear tamper HP)
–
A photo-interrupter sensor that detects the rear tamper home position.
–
When the rear tamper comes to the home position, it enters the sensor’s sensing area, which turns the
sensor to high (+5 V dc) (light blocking).
6 Rear tamper standby position
7 Rear tamper size position
8 Rear tamper offset position
Position Description