Lexmark M1242, Руководство пользователя

Страница: 71 / 140

•
If the printer has a caster base, then carefully roll it to the new location. Use caution when passing over
thresholds and breaks in flooring.
•
If the printer does not have a caster base but is configured with optional trays or output options, then remove
the output options and lift the printer off the trays. Do not try to lift the printer and any options at the same
time.
•
Always use the handholds on the printer to lift it.
•
Any cart used to move the printer must have a surface able to support the full footprint of the printer.
•
Any cart used to move the hardware options must have a surface able to support the dimensions of the
options.
•
Keep the printer in an upright position.
•
Avoid severe jarring movements.
•
Make sure that your fingers are not under the printer when you set it down.
•
Make sure that there is adequate clearance around the printer.
Note: Damage to the printer caused by improper moving is not covered by the printer warranty.
Shipping the printer
For shipping instructions, go to http://support.lexmark.com or contact customer support.
Saving energy and paper
Configuring power save mode settings
Eco
‑
Mode
1
From the control panel, navigate to:
> Device > > Power Management > > Eco
‑
Mode >
2
Select a setting.
Sleep mode
1
From the control panel, navigate to:
> Device > > Power Management > > Timeouts > > Sleep Mode >
2
Enter the amount of time that the printer stays idle before it enters Sleep mode.
Hibernate mode
1
From the control panel, navigate to:
> Device > > Power Management > > Timeouts > > Hibernate Timeout >
2
Select the amount of time before the printer enters Hibernate mode.
Maintaining the printer 71