Starting up the device – Basic configuration
Leuze electronic GmbH + Co. KG
BPS 307i
56
Tab. 8.1:
Configuration via rotary switch S2
Switch position
Position resolu-
tion [mm]
Maximum speed
[m/s]
Level of the
switching output
Speed monitoring
0
Configuration via webConfig tool
1
0.01
webConfig
webConfig
webConfig
2
0.1
webConfig
webConfig
webConfig
3
1
webConfig
webConfig
webConfig
4
10
webConfig
webConfig
webConfig
5
webConfig
webConfig
webConfig
webConfig
6
webConfig
webConfig
webConfig
webConfig
7
webConfig
0.7
• HIGH
Current speed
Below maxi-
mum speed
• LOW
Current speed
Above maxi-
mum speed
Activated
8
webConfig
2
Activated
9
webConfig
3
Activated
A
webConfig
4
Activated
F
Factory setting of the configuration parameters
Notice
: Switch S1 must be set to switch position Gray encoding.
webConfig: The parameter value set via the webConfig tool is used.
NOTICE
All parameters that are not influenced by the position of the switch are configured via the web-
Config tool; see chapter 9 "Starting up the device – webConfig tool".
In rotary switch positions
7
,
8
,
9
or
A
, the webConfig tool can be used, e.g., to change the reso-
lution of the position measurement or invert the mode of the switching inputs/outputs.
NOTICE
Rotary switch S2 on
0
if configuring with the webConfig tool!
Ä
To configure the BPS with the webConfig tool, rotary switch S2 on connection hood MK 307
or MS 307 must be set to switch position
0
.
8.7
Setting configuration parameters to factory settings
Proceed as follows:
Ä
Set slide switch S1 to switch position Gray encoding.
Ä
Set rotary switch S2 to switch position
F
.
Ä
Restart the BPS.
ð
The current parameter set of the BPS is overwritten with the parameter set containing the factory set-
tings.
