Lenovo ThinkServer RD120, Руководство по техническому обслуживанию аппаратной части

Страница: 39 / 232

2. When the message
Press F1 for Configuration/Setup
appears, press F1. If
an administrator password has been set, you must type the administrator
password to access the full Configuration/Setup Utility menu.
3. Follow the instructions on the screen.
Using the ServeRAID configuration programs
The ServeRAID controller enables you to configure multiple physical SAS hard disk
drives to operate as logical drives in a disk array. The server comes with a CD
containing the ServeRAID Manager program and the ServeRAID Mini-Configuration
program, which you can use to configure the ServeRAID controller. For information
about these programs, see the
User Guide on the ThinkServer Documentation
DVD .
Using the RAID configuration programs
Use the IBM ServeRAID Configuration Utility program and ServeRAID Manager to
configure and manage redundant array of independent disks (RAID) arrays. Be sure
to use these programs as described in this document.
v
Use the IBM ServeRAID Configuration Utility program to:
– Perform a low-level format on a hard disk drive
– View or change IDs for attached devices
– Set protocol parameters on hard disk drives
v
Use ServeRAID Manager to:
– Configure arrays
– View the RAID configuration and associated devices
– Monitor operation of the RAID controller
Consider the following information when using the IBM ServeRAID Configuration
Utility program and ServeRAID Manager to configure and manage arrays:
v
The ServeRAID-8k-l SAS controller that comes with the server supports only
RAID level-0, level-1, and level-10. You can replace it with a ServeRAID-8k SAS
controller that supports additional RAID levels.
v
Hard disk drive capacities affect how you create arrays. The drives in an array
can have different capacities, but the ServeRAID controller treats them as if they
all have the capacity of the smallest hard disk drive.
v To help ensure signal quality, do not mix drives with different speeds and data
rates.
v
To update the firmware and BIOS code for an optional ServeRAID SAS
controller, you must use the IBM
ServeRAID Support CD that comes with the
ServeRAID device.
Using the IBM ServeRAID Configuration Utility program
Use the IBM ServeRAID Configuration Utility programs to perform the following
tasks:
v Configure a redundant array of independent disks (RAID) array
v
View or change the RAID configuration and associated devices
Starting the IBM ServeRAID Configuration Utility program: To start the IBM
ServeRAID Configuration Utility program, complete the following steps:
1. Turn on the server.
Chapter 2. Configuration information and instructions
21