Lenovo ThinkCentre E73, Руководство по техническому обслуживанию аппаратной части, Страница: 147 / 190

Replacing the solid-state drive
Attention:
Do not open your computer or attempt any repair before reading and understanding “Important safety information”
on page 1.
This section provides instructions on how to replace the solid-state drive.
The solid-state drive is only available in some models. It might be installed in the hard disk drive bay or
on the bottom of the optical drive bay.
• To replace the solid-state drive in the hard disk drive bay, see “Replacing the solid-state drive in the hard
disk drive bay” on page 143.
• To replace the solid-state drive on the bottom of the optical drive bay, see “Replacing the solid-state drive
on the bottom of the optical drive bay” on page 144.
Replacing the solid-state drive in the hard disk drive bay
To replace the storage converter with the solid-state drive installed in it, you might follow the steps of
replacing the hard disk drive. See “Replacing the hard disk drive” on page 134.
To replace the solid-state drive in the storage converter, do the following:
1. Remove the four screws that secure the solid-state drive to the storage converter. Then, remove the
drive from the converter as shown.
Figure 85. Removing the solid-state drive from the storage converter
2. Take the new solid-state drive out of the static-protective package.
Chapter 10
.
Replacing FRUs (machine types: 10AU, 10AW, 10BF, and 10BG)
143