Lenovo 7D2F, Руководство по обслуживанию

Страница: 35 / 188

Table 11. System-board SW13 switch block descriptions (continued)
2
Off Disable PASSWORD_OVERRIDE
function Enable PASSWORD_
OVERRIDE function
3 Off Serial port message from Lenovo
XClarity Controller Serial port message from
uEFI
4
Off Reserved for trained service technician
5
Off Reserved for trained service technician
6
Off Reserved for trained service technician
7
Off Reserved for trained service technician
8
Off
Normal
Force RTC reset
Important:
1. Before you change any switch settings or move any jumpers, turn off the server; then, disconnect all
power cords and external cables. Review the information in
http://thinksystem.lenovofiles.com/help/topic/
safety_documentation/pdf_files.html
, “Installation Guidelines” on page 49 , “Handling static-sensitive
devices” on page 51 , and “Power off the server” on page 11 .
2. Any system-board switch or jumper block that is not shown in the illustrations in this document are
reserved.
The following table describes the functions of the button on the system board.
Table 12. Button on the server
Button name Function
Force NMI button This button is on the rear of the server. Press this button
to force a nonmaskable interrupt to the processor. You
might have to use a pen or the end of a straightened
paper clip to press the button. You can also use it to force
a blue-screen memory dump (use this button only when
you are directed to do so by Lenovo Support).
System-board LEDs
Use this information to locate the system-board LEDs.
The following illustration shows the light-emitting diodes (LEDs) on the system board.
Chapter 2
.
Server components
27